Description

【3M High quality heavy duty double sided tape】- Proven Reliability from VHB Mounting Tapes. Total 15.4 Ft/4.7M, 1/4 Inch/6mm Width,Thickness:0.04Inch/1.1mm. High strength and durability. The stickiness will gradually increase over time and display perfectly after 24 hours. 【WEATHERPROOF FOAM TAPE】- with strong resistance to moisture, humidity, and other extreme temperatures, makes it suitable for both indoor and outdoor use. It uses sealed foam to isolate water vapor, good for kitchen and bathroom. 【Flexible And Extensibility】 Simple peel, No gluing, No heating, No screwing, and No wall damage. foam tape can be extended to suit your needs. 【Easy to Use】This foam tape is easy to install, just peel off the tape and stick it to the surface of the object. And it is easy to reposition when it’s not fully compressed and repositioning will not influence adhesion durability, it bonds quickly and securely when it’s fully compressed. No drilling, no screwing, no heating. 【Multipurpose Tape】Multipurpose tape with comfortable foam on both sides provides adhesion to a variety of surfaces including LED plate, door edge, bodyside moldings, ABS and PVC rocker panels, wheel lip, nameplate, stainless steel. Product Description 3M VHB Heavy duty double sided tape This heavy-duty two-sided tape can be used for a wide array of projects. Mount bathroom fixtures in your home, add signage to the exterior of a commercial building or deck-out your car with the flashiest LED lights. It adheres firmly in minutes and becomes 100% bonded within 72 hours. Because it is particularly capable of providing a smooth, quiet and durable ride on the open road, it is the preferred automotive double sided tape for specialty vehicles. Easy Installation: 10% strength of bond in 0.5 hours 40% strength of bond in 12 hours. 80% strength of bond in 24 hours. 100% strength of bond after 72 hours. Application Guide: 1· Surface Cleaning: Quick pre-clean of tough spots if necessary. Wet cloth to remove most contaminants. Final wipe with dry cloth. 2· Priming the Surface: Primer on a disposable towel, followed by a dry towel. Dauber bottle followed by a dry towel. Foam brush. 3· Abrading Your Substrate: Light abrasion by hand. Clean the substrate after abrading to make sure all sanding debris is removed from the bond area. 4· Tape Application by Hand: Start the tape at the edge of the surface and lay it down, applying constant pressure as you go. Apply a roll down force of at least 15 lbs with a dense J-roller over the entire area to ensure good contact between the tape and the first substrate surface. Remove the protective liner to apply the other substrate. 5· Applying Final Pressure: Applying pressure to the applied tape facilitates optimal wet-out onto the substrate.